|
|
Q. Can I fit an 8-channel expander to a 40 channel GL3300?
|
|
A. We state that the maximum size of the GL3300 is 40 channels. Expanding beyond 40 channels would not be recommended due to the limitations of the power supply, and there may be additional implications in term of degradation of noise performance etc. Sys-Link
|
|
|
Q. What Power Supply Should I use with a GL4000?
|
|
A. The correct PSU is the RPS11. This can be used with an RPSD2 for connection of a backup RPS11 with autoswitching.
|
|
|
Q. With the new Version 2 software, can I run WinDR and also have SysNet control at the same time?
|
|
A. With the early releases of V2 software (V2.00, V2.01) this is not possible. You would need to disconnect WinDR to enable SysNet control and vice-versa. However V2.10 and later support the optional SysNet port, so that both can be run simultaneously. You would need to ensure that the SysNet option has the latest firmware installed.
|
|
|
Q. With the new Version 2 software, can I run WinDR and also have SysNet control at the same time?
|
|
A. With the early releases of V2 software (V2.00, V2.01) this is not possible. You would need to disconnect WinDR to enable SysNet control and vice-versa. However V2.10 and later support the optional SysNet port, so that both can be run simultaneously. You would need to ensure that the SysNet option has the latest firmware installed.
|
|
|
Q. I have an early model DR unit. Can I update it to run the latest software?
|
|
A. Yes you can. All DR units are compatible with the latest versions of software. Please note that if you want to use the optional SysNet port that was previously used with V1.xx software, you will need to ensure that the SysNet option has the latest firmware installed.
|
|
|
Q. I have an early model DR unit. Can I update it to run the latest software?
|
|
A. Yes you can. All DR units are compatible with the latest versions of software. Please note that if you want to use the optional SysNet port that was previously used with V1.xx software, you will need to ensure that the SysNet option has the latest firmware installed.
|
|
|
Q. I have a DR unit that had V2 software pre-installed, but I want to use a V1 configuration file. Can I install V1 software instead?
|
|
A. Yes you can, but it will need to be V1.83 (the latest V1 software release) which you can download from the Software page of our website. Simply follow the 'Code Update Procedure' included with V1.83 software.
|
|
|
Q. I have a DR unit that had V2 software pre-installed, but I want to use a V1 configuration file. Can I install V1 software instead?
|
|
A. Yes, you can, but it will need to be V1.83 (the latest V1 software release) which you can download from the Software page of our website. Simply follow the 'Code Update Procedure' included with V1.83 software.
|
|
|
Q. Can the I-con mixers be fitted with Digital Inputs or Outputs?
|
|
A. Unfortunately not. The internal data structure will not support standard digital outputs. Because of the intended price-point of the mixer, digital I/O was discounted at the design stage.
|
|
|
Q. Can the I-con mixers be fitted with Digital Inputs or Outputs?
|
|
A. Unfortunately not. The internal data structure will not support standard digital outputs. Because of the intended price-point of the mixer, digital I/O was discounted at the design stage.
|
|
|
|
|
|
|
